1. When the fully automatic heat shrinkable packaging machine leaves the factory, each machine is equipped with a cable to connect the power supply. The terminal lead part of the cable is equipped with the identification symbol of the power supply.

Automatic shrink packaging machine

2. When the full-automatic heat shrinkable packaging machine is used for about three months, the circuit of the shrinkable chamber should be checked thoroughly and replaced according to its aging degree.

3. Because of the high power consumption of the automatic heat shrinkable packaging machine, the input power must be greater than the power indicated on the trademark to avoid burning the circuit and electrical components.

4. attention should also be paid when equipment is installed.

5. Installation should be horizontally installed. The reliability mentioned above is based on the need to be firm and level, otherwise the service life of the electric heat pipe will be shortened. For the belt conveyor, its tilt installation will cause the conveyor belt to deviate from the center.

6, we must choose safe and reliable grounding conditions to ensure that personal safety is the primary issue.

7, a mistake that many operators easily make is to cut off the power directly after the end of the packaging work. The correct operation should be to turn off the heating switch, let the conveyor motor and fan motor continue to run about 10 minutes, and then cut off the entire power supply.

Food shrink packaging machine

Main configuration of automatic shrink packaging machine

1. Quartz tube: It is directly heated by far infrared radiation, continuously variable electronic speed, solid-state voltage regulator temperature control, stable and reliable;

2. Stainless steel heating pipe: high-quality stainless steel heating pipe, internal two-way thermal cycle air, heat uniform, constant. With electronic governor, the conveying speed can be adjusted arbitrarily to ensure the conveying stability and good shrinkage effect.